Yamaha WR450F(V) Owner's Service Manual page 610

b
1
64˚
c
3
5 - 42
HANDLEBAR
3. Tighten:
• Nut [handlebar holder (lower)] 1
40 Nm (4.0 m · kg, 29 ft · lb)
4. Install:
• Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
• Before applying the adhesive, wipe off
grease or oil on the handlebar surface a
with a lacquer thinner.
• Install the grip (left) to the handlebar so that
the line b between the two arrow marks
faces straight upward.
5. Install:
• Grip (right) 1
• Collar 2
Apply the adhesive on the tube guide 3.
NOTE:
• Before applying the adhesive, wipe off
grease or oil on the tube guide surface a
with a lacquer thinner.
• Install the grip to the tube guide so that the
grip match mark b and tube guide slot c
form the angle as shown.
6. Install:
• Cover (grip cap) 1
• Throttle grip 2
NOTE:
Apply the lithium soap base grease on the
throttle grip sliding surface.
CHAS