Rear Wheel - Yamaha PW80(X) Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR

Rear wheel

To remove the rear wheel
1
WARNING
2
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motorcy-
3
cle so that there is no danger of
it falling over.
4
1. Loosen the axle nut.
5
1
6
7
5
8
4
9 1. Drive chain slack adjusting nut
2. Locknut
3. Chain puller
4. Washer
5. Axle nut
2. Remove the brake pedal free play
EAU25080 adjusting nut, and then disconnect
the brake rod from the brake cam-
shaft lever.
EAU41560
EWA10820
1. Brake pedal free play adjusting nut
2
2. Spacer
3. Chain puller
4. Wheel axle
5. Drive chain slack adjusting nut
6. Locknut
7. Brake torque rod
8. Brake torque rod bolt
3
9. Cotter pin
10. Brake torque rod nut
3. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut, and
the bolt.
4. Loosen the locknut and drive chain
adjusting nut on each end of the
3
4
2
6
7
8
1
9
10
6-26
swingarm.
5. Lift the rear wheel off the ground
according to the procedure on
page 6-23.
6. Remove the axle nut and washer,
and then pull the wheel axle out.
7. Push the wheel forward, and then
5
remove the drive chain from the
rear sprocket.
NOTE:
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
8. Remove the spacer, chain pullers
and wheel by pulling it back.