Crossover ® Ignition System Operations; Replace Igniter Batteries - Weber Summit Series Owner's Manual

36
13. Remove the Crossover ®
14. Pull the selected burner(s) tube(s) from manifold frame and replace
with a new burner tube.
15. To reinstall the manifold assembly, reverse steps 7 through 14.
CAUTION: The burner openings (1) must be positioned
properly over the valve orifi ces (2).
Check proper assembly before fastening manifold in place.
WARNING: After reinstalling the gas lines, they should
be leak checked with a soap and water solution before
using the grill. (See, "Check for gas leaks.")
CROSSOVER IGNITION SYSTEM OPERATIONS
®
®
If the Crossover ignition system fails to ignite the LEFT burner in a burner
set, light the LEFT burner with a match. If the LEFT burner lights with a
match, then check the Crossover
• Check that both ignition wires(1,2) are attached properly.
• Check that the Crossover ®
• You should hear the igniter sparking.
If the Crossover ® ignition system still fails to light, contact the Customer
Service Representative in your area using the contact information on our
web site. Log onto www.weber.com

REPLACE IGNITER BATTERIES

Parts required: 1 AA alkaline battery per igniter.
Unscrew igniter button from bottom of control panel. Remove igniter button
and contact spring. Remove old battery and replace with a new AA alkaline
battery. Positive end(1) of battery faces up as shown in illustration. Replace
spring contact(2) and screw igniter button(3) back down.
MAINTENANCE
tube.
® ignition system.
ignition button is activating.
® .
(2)
(1)
(1 )
(2 )