Program *50 - Caller Id Circuit Assignments To Co Line Pcbs - Toshiba DK14 Programming Manual

Program *50 – Caller ID Circuit Assignments to CO
Line PCBs
Processor Type:
Program Type:
Initialized Default:
✱ ✱ ✱ ✱
Processor
DK14
DK40i
RCTUA
RCTUBA/BB
RCTUC/D
RCTUE/F
B1CU
B2CAU/BU
B3CAU/BU
B5CAU/BU
RCIU/RCIS Circuit
CO Line Number
Number Assigned
The Tip/Ring leads of RGLU, RCOU, RCOS, and PCOU Caller ID CO lines assigned to
Note
RCIU2/RCIS circuits must be bridged at the MDF. The Tip/Ring leads of TCOU and
TCIU2 are bridged by the PCB connectors in the DK40i Base KSU.
For more information on RCIU/RCIS assignments and installation, refer to Chapter 7 –
Universal Slot PCB Installation and Chapter 8 – Universal Slot PCB Wiring Diagrams in
the Strata DK I&M Manual.
On DK14, the Tip/Ring leads of the CO line circuit must be connected to the line Tip/Ring
leads of the Caller ID interface box. (See Chapter 1 – DK14 Installation, Figure 1-18 and
the Caller ID text under "WSIU1 Serial Interface Board" in the Strata DK I&M Manual.)
Strata DK Programming 5/00
DK14, DK40i, all RCTUs and BCUs
System
No RCIU/RCIS circuits assigned
✱
CO Line Range
001~004
001~012
001~016
001~048
001~144
001~200
001~032
000~120
000~120
000~200
CO Line Number
Program *50 – Caller ID Circuit Assignments to CO Line PCBs
Run Program 91-2
System power must be cycled or Program 91-2 must
be run after completing *50 data entry to transfer
data from temporary memory to working memory.
CIUNO = RCIU/RCISU Caller ID circuit number
(001~200) or use LED Button 01 to erase data. For
DK14, enter the Caller ID interface box line number
(001~004).
Any Caller ID circuit can be assigned to any analog
ground or loop start CO line circuit. Circuit numbers
do not have to match.
RCIU/RCIS Circuit
CO Line Number
Number Assigned
System & Station
RCIU/RCIS Circuit
Number Assigned
3-131