Advertisement
Quick Links
TOSHIBA POS TERMINAL
ST-B10 SERIES
Quick Installation Manual
This sheet contains only the quick Installation procedures. Please be
sure to read the Owner's Manual in the web site for further information
about this POS terminal.
Important Information to the User
In order to meet Product Safety and EMC legal Requirements, it is advised to socket
the power cord, and interface cable in accordance with the following instructions
Otherwise these devices need to meet following standards.
Interface Cable
You are advised to use a shielded (360 degrees) interface cable with this product.
The shield must be connected to the frame or earth ground connection or earth
ground reference at BOTH ends of the cable.
If another cable is used than described above you will need to test this cable with the
TOSHIBA TEC POS terminal and your system for FCC and CE mark certification.
Power Cord
For this product a UL listed, detachable power cord is required. When the power
supply is mounted on the floor, a power cord with Type SJT marking is required.
Outside the US, power cords need to meet the particular country's certification and
application requirements. If a power cord is used different from described above you
might violate safety certifications, which are in force in the country of use.
Caution
The socket-outlet needs to be installed near the equipment and must be easily
accessible.
Do not connect the LAN cable wired outside of a building to the LAN port provided on
this product directly. The LAN port is intended for indoor connection.
If the product is connected to the LAN cable wired outside of a building, be sure to
use any communication equipment, such as a router, a hub, or a modem, which is
located within the same building as the product is installed.
Note
The ST-B10 does not support the hot plug / hot unplug features of the Powered USB
interface. In case of plugging or unplugging the Powered USB peripherals attached to
the ST-B10, you are requested to power off the ST-B10.
1
Advertisement
Related Manuals for Toshiba ST-B10 SERIES
Summary of Contents for Toshiba ST-B10 SERIES
- Page 1 BOTH ends of the cable. If another cable is used than described above you will need to test this cable with the TOSHIBA TEC POS terminal and your system for FCC and CE mark certification. Power Cord For this product a UL listed, detachable power cord is required.
- Page 2 1. APPEARANCE [Unit: mm] HDD Panel Power Switch er LED HDD LED Error LED...
- Page 3 (1) Power Switch This is the switch to turn the power of the POS terminal ON or OFF. The Power LED is illuminated when turning the power on. (2) Power LED (Blue) This is the LED to indicate the power ON/OFF status of the POS terminal. Blue LED is illuminated when turning the power ON.
- Page 4 2. CONNECTORS CAUTION! The drawer interface connector is exclusively for connecting the drawer. Do not connect a phone line or any other cables than the drawer cable to this connector. Doing so may cause a failure of the phone line and this POS terminal. PS/2 (Mouse) Powered USB 12V PS/2 (Keyboard)
-
Page 5: Installation Procedure
3. INSTALLATION PROCEDURE 3.1 Environment for Installation CAUTION! When installing the POS terminal, take the following precautions. Failure to do this may cause fire, electric shock, or injury. 1. Avoid locations where it is subject to the following: • Direct sunlight •... -
Page 6: Connecting The Ac Plug
1. Fully insert the Power Cord Plug into the AC Inlet. AC Inlet NOTE: The Power cord is not included in the carton. Please prepare it separately from local dealer. < For EU only > TOSHIBA TEC Europe Retail Information Copyright © 2010 by TOSHIBA TEC CORPORATION Systems S.A All Rights Reserved Rue de la Célidée 33 BE-1080 Brussels...