Step 11. The LED panel is pined to the front bezel. Pull the pins outward to release it
the LED panel out as shown.
Step 12. To install the new the LED panel:
a.
Line up the new LED panel with the front bezel, then slide it into position.
b.
Secure the LED panel to the front bezel with the 2 screws.
c.
Attach all the cables to the new LED panel.
d.
Reattach the converter bracket to the front bezel.
e.
Reattach the converter board to the bracket.
f.
A converter jumper setting is required after replacing the old panel with a new panel. Follow the
below diagram to insert the jumper heads to the pins properly depending on the panel brands:
2 3
1
, then slide out
.
Chapter 8
Replacing hardware
45