Using Your Iron - GE 106636 Owner's Manual

840084900 Ev01 5/24/01 1:44 PM Page 4

Using Your Iron

To Dry Iron
1. Plug iron into electrical outlet. The
Auto Shutoff Reset Button/Light will
come on. If the plug will not fit,
read about the polarized plug in
"Consumer Safety Information."
2. Turn the Temperature/Steam Dial to
NOTE: To dry iron at setting 4 and
higher, empty all water from the
iron.
3. Preheat for about four minutes
before beginning to iron.
To Steam Iron
1. Fill water tank following instructions
in "Filling the Water Tank."
2. Plug iron into electrical outlet. The
Auto Shutoff Reset Button/Light will
come on. If the plug will not fit, read
about the polarized plug in
"Consumer Safety Information."
3. Turn the Temperature/Steam Dial
4. Preheat for about four minutes
before beginning to iron.
4
4. The iron will automatically shut off
a setting in the
Dry Iron range,
5. When finished ironing, turn the
settings 1-3. As
an example, the
illustration
shows the iron
set at 2 (Nylon).
5. The iron will automatically shut off
one hour after the iron is plugged in
and the Auto Shutoff Reset Button/
Light will go out. To turn the iron
back on, press the Auto Shutoff Reset
Button/Light located on the top of
the handle.
6. When finished ironing, turn the
to a setting in
the Steam Iron
range, settings
4-9. As an
example, the
illustration
shows the iron
set at 7 (Rayon).
one hour after the iron is plugged
in and the Auto Shutoff Reset
Button/Light will go out. To turn
the iron back on, press the Auto
Shutoff Reset Button/Light located
on the top of the handle.
Temperature/
Steam Dial to
0 (OFF) and
unplug iron.
Temperature/
Steam Dial to
0 (OFF) and
unplug iron.
Allow to cool
and empty water
from water tank.
See "Storing
Your Iron."