Adding Paper To Tray 1, 2, Or 3 - Hitachi DDS 32 Quick Reference Manual

Adding Paper to Tray 1, 2, or 3

(Tray 3 when High Capacity Feeder (HCF) Installed).
1. Pull out the tray until it stops.
2. Gently lift up the guide and slide it until it stops.
Note:
Skip this step if you are not changing paper size.
3. While pressing down the gray handle, slide the guide until it stops.
4. Place the paper in the tray between the guides.
5. Adjust the guides to the paper width and length.
6. Push the tray in until it latches.
Note:
The paper stack height should not exceed the limit mark as shown in the illustration for step 4.
Adjust the guides to allow the paper to lie flat between them. Improperly adjusted guides can cause
the paper to curl and jam.
Be sure the guide stop is locked firmly in the guide hole on the tray.
Quick Reference Guide
1
4
2
5a
6
3
5b
5