Advertisement
Quick Links
Installation
Instructions
Before you begin – Read these instructions completely and carefully.
Note to Installer: Be sure to leave these instructions with the Consumer.
Note to Consumer: Keep these instructions with your Owner's Manual for future reference.
Right hand door swing models are illustrated in these
instructions. Follow these same instructions for left hand
models.
This kit provides for the installation of Tubular Stainless
Steel handles or custom handles on 3/4" overlay custom
panels.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 7/32", 1/8" bits and 7/8" spade bit
• Custom door panels,
• Safety glasses
• Center punch
• Hammer
• Pencil
Parts List:
A. Freezer tubular handle (95376) and
fresh food tubular handle (95377)
B. 4 Handle standoffs, 70536
C. 6 Screws for handle standoffs
#10-32x1" pan head machine screws (4 required, 2 extra), 36298
D. 6 Set screws (4 required, 2 extra) 70539
E. 3/32" Allen wrench for set screws, 70548
F. 6 Plastic spacers (4 required, 2 extra) 70540
G. 5 Trim screws (4 required, one extra) 8665
H. Handle side trim for LH models (75468), trim for RH models (75469)
STEP 1 REMOVE DOOR AND
DRAWER HANDLES
• Open refrigerator door to 90 . Remove the 4 screws
holding the handle to the door.
• Remove 4 screws holding handle side trim. Discard all
screws and trim. Discard handle.
• Open freezer drawer to access handle and trim.
Remove and discard handle, retain screws and trim.
If you are installing custom handles, go to STEP 3.
ZKHCSS2
Tubular Stainless Steel Handles
and Handle Side Trim
A
B
C
D
H
F
E
G
Advertisement
Related Manuals for GE ZKHCSS2
Summary of Contents for GE ZKHCSS2
- Page 1 • Remove 4 screws holding handle side trim. Discard all screws and trim. Discard handle. • Open freezer drawer to access handle and trim. Remove and discard handle, retain screws and trim. If you are installing custom handles, go to STEP 3.
- Page 2 • Follow the same procedure to drill pilot holes on the freezer door. Assemble Handles • Place a handle standoff on each attachment post on the handle. Position the screw hole on the standoff to point to the floor.
- Page 3 STEP 3 INSTALL ASSEMBLED PANELS Install 4 Handle Side Trim Screws • Install custom handles according to the manufacturer’s instructions. • Slide assembled door panel into the trim. • Determine the correct trim for your model (for left or right door swing).
- Page 4 Pub. No. 31-46033-2 Dwg. No. 197D4869P001 (N.D. 532) 9/02 75470 Note: While performing installations described in this book, safety glasses or goggles should be worn. ® For Monogram local service in your area, call 1-800-444-1845. Note: Product improvement is a continuing endeavor at General Electric.