Table of Contents
Advertisement
orientation and that all mating pins are seated fully and
uniformly.
5.
Insert the Series-2 Module
(P/N 64709) into the Adapter Board — ensure that the
module is inserted with the correct orientation and that all
mating pins are seated fully and uniformly.
6.
Close the front door or reattach the front cover (device-
specific).
7.
Apply system/ASD power.
Note:
RJ-45 Transceiver Installation
1.
Perform steps
the
Series-2 Transceiver
Module Installation on
page
8.
2.
Insert the transceiver
module into the RJ-45
connector of the 7-Series (CNU1) or 9-Series (S4) ASD
terminal board.
PC USB Transceiver Installation
1.
Insert the USB
Transceiver Module
into any unused USB
port of the PC.
Once the module is
properly inserted into
the USB port of the PC, the Found New Hardware Wizard
dialog box appears.
2.
Continue to step
Verification on page
NetPac Wireless System
CNU1 of the control board CANNOT be used
while using the Toshiba NetPac Wireless System.
1
and
2
of
1
of the
Software Installation and
11.
9
Advertisement
Table of Contents
