Tv Brand Codes - Amino Remote Control User Manual

4.1 TV Brand Codes

In order for the remote to transmit the correct signals to control the TV, the remote must be
programmed with a 3-digit code corresponding to the type of TV in use.
This is done in the following way:
• Identify the make of the TV that is in use. E.g. Sony, Magnavox etc.
• Find the TV make listed in the branding table in Appendix A.
• Simultaneously press and hold the TV
and OK buttons on the remote.
• After approximately 2 seconds, the TV button will light.
• Release the TV and OK buttons – the TV button remains illuminated.
• Now enter the 3-digit brand code according to the make of the TV that is being controlled.
• As each of the digits are entered, the TV button will briefly flash off and on again
• When the third digit has been entered, the TV button will go out.
• If a TV brand code has been entered that the remote does not recognize, the TV button will
flash rapidly for a second and remain illuminated. If this happens, re-enter the correct TV brand
code.
• Verify that the remote control works with the TV.
Most TV makes have more than one brand code listed in the brand code table – if this is the
case try all brand codes that are listed for that make until a suitable match is found.
If no brand code is listed for the TV, try brand codes for Philips and NEC TVs.
Page 4