Power On / Off - Panasonic TH-50PB2U Operating Instructions Manual

Power ON / OFF

Connecting the AC cord plug to the Plasma Display.
Connecting the plug to the Wall Outlet.
Note:
When disconnecting the AC cord, be absolutely sure to
disconnect the AC cord plug at the socket outlet fi rst.
Press the Power switch on the Plasma Display to turn the
set on: Power-On.
Power Indicator: Green
[Starting up the network]
It takes some time for the network to start up just after the
power is turned on.
During that time, "NETWORK SETUP" in the "SETUP"
menu is grayed out and cannot be set.
Press the
Power Indicator: Red (standby)
Press the
Power Indicator: Green
Turn the power to the Plasma Display off by pressing the
when the Plasma Display is on or in standby mode.
Note:
During operation of the power management function, the power indicator turns
orange in the power off state.
button on the remote control to turn the Plasma Display off.
button on the remote control to turn the Plasma Display on.
+
INPUT MENU -/ VOL / ENTER/
Power Indicator
Remote Control Sensor
switch on the unit,
15