Connector And Jumper Description; Mounting Orientation; Figure 25. Mounting Hole Locations Of The Djsa-232/230 - IBM DJSA-210 - Travelstar 10 GB Hard Drive Specifications
2.5 inch ata/ide hard disk drive
Hide thumbs
Also See for DJSA-210 - Travelstar 10 GB Hard Drive:
- Quick installation manual (2 pages)
Table of Contents
Advertisement
the DJSA-232/230
Figure 25. Mounting hole locations of
6.5.3 Connector and jumper description
A jumper is used to designate the drive address as either master or slave. The jumper setting method is
described in section 7.10.
Connector specifications are included in Part 2 of this document—Electrical Interface specifications.
6.5.4 Mounting orientation
The drive will operate in all axes (6 directions) and will stay within the specified error rates when tilted
±5 degrees from these positions.
Performance and error rate will stay within specification limits if the drive is operated in the other
permissible orientations from which it was formatted. Thus a drive formatted in a horizontal orientation will
be able to run vertically and vice versa.
The recommended mounting screw torque is 3.0±0.5 kgf-cm.
The recommended mounting screw depth is 3.0±0.3 mm for bottom and 3.5±0.5 mm for horizontal
mounting.
Travelstar 32GH/30GT/20GN hard disk drive specifications
32
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DJSA-210 - Travelstar 10 GB Hard Drive and is the answer not in the manual?
Questions and answers