GE 164D2966P205-1 Use And Care Manual page 32

OPERATING THE SELF-CLEANING OVEN
How to Set Delay Start of Cleaning
Easy Steps:
1. Press AUTO SELF CLEAN.
2. Press the number pads to set the clean time.
3. Press DELAY START.
4. Press the number pads to set the start time.
5. Press START.
Delay Start is setting the oven to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the steps in the Before a Clean
Cycle section.
2. Press AUTO SELF CLEAN.
AUTO SELF
CLEAN
3. Press the number pads to set the
clean time.
4. Press DELAY START.
DELAY
START
5. Press the number pads to set the time of
day you want the clean cycle to start.
6. Press START.
START
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
steel wool pad. Be sure to rinse thoroughly with a
vinegar and water mixture. These deposits are usually
a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
32
(continued)
The door locks automatically. The display will show
the start time. It will not be possible to open the oven
door until the temperature drops below the lock
temperature and the LOCKED DOOR light goes off.
7. When the LOCKED DOOR light is off, open
the door.
NOTE: You can set a delay clean in both ovens at
the same time. The second oven set will
automatically delay the start of cleaning until the
end of the first oven's clean cycle.
NOTE:
• No functions can be programmed before the door
automatically unlocks.
• If the shelves have become hard to slide, wipe the
shelf supports with cooking oil.