Troubleshooting - Weslo Cadence 45 Treadmill User Manual

English manual

Hide thumbs Also See for Cadence 45 Treadmill:

Manuel de l'utilisateur (28 pages)

User manual (24 pages)

User manual (19 pages)

Table Of Contents

Table of Contents

TROUBLESHOOTING

Most treadmill problems can be solved by following the simple steps below. Find the symptom that ap-

plies, and follow the steps listed. If you need further assistance, please call the telephone number on the

front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 10). Use only a single-outlet surge suppres-

sor that meets all of the specifications described on page 10. Important: The treadmill is not com-

patible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the reset/off circuit breaker located on the

treadmill frame near the power cord. If the switch

protrudes as shown, the circuit breaker has tripped.

To reset the circuit breaker, wait for five minutes

and then press the switch back in.

PROBLEM: The power turns off during use

SOLUTION: a. Check the reset/off circuit breaker located on the treadmill frame near the power cord (see the

drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch

back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for

five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key into the console.

d. If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE

POWER CORD. Remove the Hood Screws (26) from

the Hood (1), and carefully pivot the Hood off.

Locate the Reed Switch (10) and the Magnet (18) on

the left side of the Pulley (17). Turn the Pulley until

the Magnet is aligned with the Reed Switch. Make

sure that the gap between the Magnet and the

Reed Switch is about 1/8 in. (3 mm). If necessary,

loosen the 3/4" Tek Screw (58), move the Reed

Switch slightly, and retighten the Screw. Reattach the

Hood (not shown), and run the treadmill for a few min-

utes to check for a correct speed reading.

Tripped

1/8 in.

Top

View

Reset

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Need help?

Do you have a question about the Cadence 45 Treadmill and is the answer not in the manual?

Questions and answers

Alan

April 7, 2025

What to do if the unit has not been used for years and stored in a garage in a somewhat humid climate.

1 comments:

Mr. Anderson

April 9, 2025

If a Weslo Cadence 45 Treadmill has been stored in a humid garage for years, take these maintenance steps:

1. Inspect for Damage: Check the power cord, plug, and all parts for signs of damage or corrosion. Do not operate the treadmill if any parts are damaged.

2. Move Indoors: Relocate the treadmill to a dry, indoor area away from moisture and dust. Do not use it in a garage or near water.

3. Clean the Treadmill: Wipe down all surfaces to remove dust, debris, or moisture buildup.

4. Check Air Openings: Make sure no air openings are blocked to allow proper ventilation.

5. Use a Surge Suppressor: Connect the treadmill to a grounded outlet using a UL 1449 listed surge suppressor with a suppressed voltage rating of 400 volts or less.

6. Test Operation: Plug in the treadmill and test for proper function. If it is not working correctly, refer to the troubleshooting section.

7. Do Not Modify Electrical Components: Use the correct plug and outlet without modification.

If the treadmill still does not operate properly, service may be required.