Power Windows; Power Window Switches - Fiat 500 Owner's Manual

2013
Hide thumbs Also See for 500:
Table of Contents

Advertisement

22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
Autoclose — If Equipped
When enabled, the door locks will lock automatically
when the vehicle's speed exceeds 15 mph (24 km/h).
To change the setting proceed as follows:
1. Briefly press the SET ESC button "On" or "Off" will
flash on the display (according to the previous set-
ting).
2. Press the UP
or DOWN
3. Briefly press the SET ESC button to go back to the
menu screen, or press and hold the SET ESC button
(approximately one second) to go back to the main
screen without storing the settings.
NOTE: Use the Automatic Door Locks feature in accor-
dance with local laws.
Refer to "Electronic Vehicle Information Center (EVIC)"
in "Understanding Your Vehicle" for further information.
button for setting.

POWER WINDOWS

Power Window Switches

There are single window controls located on the shifter
bezel, below the climate controls, which operate the
driver and passenger door windows. The window con-
trols will operate when the ignition switch is in the
ON/RUN position.
WARNING!
Never leave children in a vehicle with the key in the
ignition switch. Occupants, particularly unattended
children, can become entrapped by the windows
while operating the power window switches. Such
entrapment may result in serious injury or death.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 500 and is the answer not in the manual?

Questions and answers

Jeff Haddock
March 22, 2025

Oil was overfilled. Then would not start. Drained to correct amount. Still will not start. How do I reset.

1 comments:
Mr. Anderson
March 22, 2025

The provided context contains information on resetting the oil change light and checking oil levels but does not explicitly mention how to reset the Fiat 500 after overfilling the oil and it won't start. However, if the engine won't start due to overfilled oil, you may need to drain the excess oil to bring the level within the recommended range. After correcting the oil level, try starting the car again. If the issue persists, further diagnostics may be required.

This answer is automatically generated

This manual is also suitable for:

500c2013 5002013 500c

Table of Contents

Save PDF