Recovery Tank - GE 71722 Owner's Manual

FIGURE 1
Recovery
Tank
Latch
Recovery
Tank
Slide
Automatic Shut-Off
The automatic suction shut-off functions when the recovery tank is full of liquid. This can be
detected by a noticeable difference in the motor sound. Immediately turn off the unit when
this happens and empty the recovery tank.
B. Emptying the Recovery Tank
NOTE: Turn off the power switch and unplug the carpet shampooer/
extractor to empty the recovery tank.
1) Press the recovery tank latch downward to release the tank from the carpet
shampooer/extractor unit as shown in Figure 1.
2) Slide the recovery tank out from the lower portion of the carpet
shampooer/extractor unit.
3) Lift off the recovery tank lid and empty contents into a suitable water
drain.
4) Rinse out the recovery tank and tank lid thoroughly.
5) Remove and clean the filter by rinsing it with water after each use. Place
the same filter back in the recovery tank as shown in Figure 2.
6) Replace the recovery tank lid by aligning notches in lid over tank tabs.
7) Close lid securely.
8) Return the recovery tank to the carpet shampooer/extractor unit.
9) Push the recovery tank all the way into carpet shampooer/extractor until
secure. Be sure the ridge on the latch snaps securely in place.
10) Resume cleaning.
FIGURE 2

Recovery Tank

Tank Lid
Lift
Filter
9