NEC Express5800 320La System Configuration Manual page 63

Express5800/ft Maintenance
Express5800/ft series maintenance can be performed in two ways; one is to use
ESMPRO Manager for remote maintenance and the other is to use the
ft Server Utility located on the managed Express5800/ft server.
Note:
To start the NEC ESMPRO Agent ft server utility installed in the
NEC Express5800/ft, type:
/opt/nec/esmpro_sa/ESMftcutil
The maintenance functions that can be executed from ESMPRO include three
types, those common to all components, those specific to particular components,
and general system settings.
The table below lists the maintenance functions for specific components in your
server and indicates how the functions of these components may be executed.
Component
module Start/Stop
CPU module
MTBF Log Clear
module Diagnostics
Firmware Update
Dump Acquisition (during operation)
Dump Acquisition (stopped module)
Board Switch
PCI module module Start/Stop
MTBF Log Clear
module Diagnostics
Ethernet Adapter MTBF Log Clear
SCSI Bus Bus Reset
SCSI Enclosure MTBF Log Clear
SCSI Electronics
SCSI Slot
BMC Firmware Update
System Quick Dump, Auto-firmware Update, Auto-
module Start
SCSI Disk Preventive Disk Maintenance Setup
SCSI Adapter MTBF Log Clear
Function
Control
Locally Remotely
ft Server Utility ESMPRO
Manager
yes yes
yes yes
no no
yes no
yes yes
yes no
no no
yes yes
yes yes
no no
yes yes
no yes
no no
yes no
no no
yes no
yes yes
Monitoring the ft Server 4-3