Figure 7.3.1 Troubleshooting Guide - GBC 930-115 Operator's Manual

Operations Manual

Figure 7.3.1 Troubleshooting guide

Symptom
Laminator won't run.
Feeder not picking up sheets.
Feeder head not moving.
Sheets not feeding straight.
Sheets wrinkled.
Film stretching or shrinking.
Film not sticking.
Excessive upward curl.
Excessive downward curl.
Cutter not cutting.
Sheets not exiting the back of the machine.
© 2004 General Binding Corporation
Solution
Verify that unit is plugged in and power is present.
Check control panel for machine status.
Check fuses.
Feed pile light must be on.
Check pick up heads.
Check suction at pick up heads.
Check air blast.
Check pile height proximity switch.
Insure that paper is properly stacked and fanned.
Check fuse.
Verify sheet feed eye (1st eye) is clean.
Check Pile Height pinching leading edge under tray
Check for uneven pressure on in-feed rollers.
Check side guides on table.
Check for obstructions on in-feed plate.
Check Air Blast
Film tension not set properly.
Adhesive or paper on rollers.
Roller pressure uneven.
Crooked infeed.
Pull out roller pressure uneven.
Speed too slow.
Film tension too high.
Film tension too high on core chuck.
Binding of core chuck on shaft.
Machine not up to heat.
Running too fast.
Nip roller pressure not set properly.
Using incorrect film.
Brake or film tension set too high.
Decurling bar not set properly.
Decurling bar not set properly.
Cutter not in home position.
Check fuse.
Cutter and detector out of alignment with film web.
Film web to close too edge of paper.
Web running over blade.
Overlap too small
Use paper pin
Check fuse.
Pressure on pull out rollers not set properly.
Obstructions in cutter area.
Use exit clips.
Sheet not flat.
Polaris II
Page 7-3