step 3:
(see FIGUre 3)
•
Tighten all hex nuts and bolts, following the same
sequence as assembled in steps 4, 5 and 6. do not
collapse tube when tightening.
•
Assemble a spacer and then a 1/2" flat washer onto
each end of the axle.
FIGUre 3
step 4:
(see FIGUre 4)
•
Place the wheel (long end of hub first) onto the end of
the axle that has no indents.
•
10. Place a 1/2" flat washer onto the axle and then
lightly tap a hub cap onto the axle until it is snug
against the washer and wheel hub.
1/2" FLAT
WASHER
HUB CAP
FIGUre 4
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
AXLE
SPACER
1/2" DIA.
FLAT WASHER
END WITH NO
CROSS HOLE
step 5:
(see FIGUre 5)
•
Place the drive wheel onto the end of the axle that
has an indent. The long end of the hub goes to the
inside.
•
Place a hub cap onto the end of the axle. Using a
small hammer, lightly tap the hub cap until it is snug
against the wheel.
HUB CAP
FIGUre 5
step 6:
(see FIGUre 6)
•
In order to assemble the hitch bracket to the hitch
tube, turn the spreader upright on its wheels.
Assemble the bracket to the top of the hitch using two
1/4" x 1" hex bolts and 1/4" nylock nuts.
HITCH PIN
FIGUre 6
1/4" x 1"
HEX BOLT
1/4" NYLOCK
NUT
HAIR COTTER PIN
5