Table of Contents
Advertisement
Guided Tour - UT-4
6: MIC Level control (trimpot) - If you are using the UT-4 with a
lavalier microphone, use the supplied plastic screwdriver to set this
input sensitivity control to the optimum level. See the "Setting Up and
Using the UHF Series System" section on page 15 for more information.
7: Input switch - Set this to either the "GTR" position (if you are using
the UT-4 with an instrument such as an electric guitar or bass) or to the
"MIC" position (if you are using it with a lavalier or headset microphone).
8: GTR Level control (trimpot) - If you are using the UT-4 with an
instrument such as an electric guitar or bass, use the supplied plastic
screwdriver to set this input sensitivity control to the optimum level.
See the "Setting Up and Using the UHF Series System" section on
page 15 for more information.
9: Battery holder - Insert a standard 9-volt alkaline battery here, being
sure to observe the plus and minus polarity markings shown.
10: Plastic screwdriver - Specially designed for use in adjusting the
UT-4 MIC or GTR Level controls (see #6 and #8 above). See the
"Setting Up and Using the UHF Series System" section on page 15 for
more information.
11
Advertisement
Table of Contents
