Advertisement
{}: ,Oi_% i i ¸ ¸¸_i
@{i:}q_ % %;i'_i_
i '¸
1. Using a 4" (10.2 cm) clamp, connect vent to exhaust outlet in
washer/dryer. If connecting to existing vent, make sure the
vent is clean. The vent must fit over the exhaust outlet and
inside the exhaust hood. Make sure the vent is secured to
exhaust hood with a 4" (10.2 cm) clamp.
2. Move washer/dryer into final position. Do not crush or kink
vent. Make sure washer/dryer
is level.
3. (On gas models) Check to be sure there are no kinks in the
flexible gas line.
CIo !A' _ ii!i3_iie{x,:}i!_
¸¸ii i i%!sk:i:_iii
ki:iH(}i!!'%
1. Check to be sure all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check to be sure you have all of your tools.
3. Dispose of/recycle all packaging materials. Keep the plastic
foam for use if the washer/dryer
should be transported.
4. Check the washer/dryer's final location. Be sure the vent is not
crushed or kinked.
5. Check to be sure the washer/dryer
is level and front leveling
feet are tight. See "Level Washer/Dryer."
6. Plug into a grounded 3 prong outlet. Turn on power.
7. Check to be sure the water faucets are on.
8. Check for leaks around faucets and inlet hoses.
g. Remove the blue protective film on the console and any tape
remaining on the washer/dryer.
10.
11.
12.
13.
14.
Read your Use and Care Guide.
Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
To test the washer, measure r/2the normal recommended
amount of detergent and pour it into the washer. Close the lid.
Select the REGULAR cycle and pull out the Cycle Control
knob. Allow the washer to complete one whole cycle.
To test the dryer, set the dryer on a full heat cycle (not an air
cycle) for 20 minutes and start the dryer.
If the dryer will not start, check the following:
•
Washer/dryer is plugged into a grounded 3 prong outlet.
•
Start button has been firmly pushed.
•
Electrical supply is connected.
•
House fuse is intact and tight, or circuit breaker has not
tripped.
•
Dryer door is closed.
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you do not feel heat, turn off the
dryer and check to see whether the gas supply line shutoff
valve is open.
•
If the gas supply line shutoff valve is closed, open it, then
repeat the 5-minute test as outlined above.
•
If the gas supply line shutoff valve is open, contact a
qualified technician.
8566267
@ 2004.
All rights reserved.
Benton Harbor, Michigan 49022
10/04
Printed in U.S.A.
Advertisement
