Advertisement
Available languages
Available languages
USEANDCARE
WARNING:
Many areas of an outdoor gas grill generate
extreme
heat. We have taken
every precaution
to protect you from the contact areas. However,
it is impossible
to
isolate all high-temperature
areas. Therefore,
use good judgment
and caution when
grilling on this product. We suggest
a covered,
protected
hand during operation
of grill.
Do not move your grill when it is in operation
or hot to the touch. Wait until your unit is
turned off and properly
cooled down before moving it. Failure to follow this warning
could result in personal
injury.
Do not operate the gas grill indoors or in any enclosed
area. If the gas grill is not in use, the
gas must be turned off at the supply tank. If the grill is to be stored indoors, disconnect
the
gas supply hose.
When checking
for gas leaks, do not use an open flame. Use a soapy water solution
and
apply it to the pipe joints and fittings with a brush and check for bubbles.
Check flexible hoses
for cuts and wear that may affect the safe operation
of the grill. Only use original equipment
replacement
hoses. Use only replacement
hose assemblies
specified
by manufacturer.
Checking
Gas Leaks
Before operating
your grill, after refueling,
check carefully to be certain that all connections
are tight and there are no gas leaks.
1. Make 2-3 ounces of leak solution
by mixing liquid dishwashing
soap with water.
2. Make certain all control knobs are in the "OFF" position.
3. Brush small amounts
of the leak solution
on all the fittings and turn the gas on.
4. If bubbles appear, there is a leak. Proceed to step 5.
5. Turn the gas off and tighten all connections.
6. Go back to step 1 to retest the fittings.
7. If bubbles continue to appear, turn the gas off. Contact customer
service.
WARNING:
Never use a match or open flame for leak detection.
Use of an open flame
could result in a fire, explosion
and bodily harm.
IMPORTANT:
When connecting
or replacing
any gas pipe or fittings,
all joints must be
sealed with approved
leak-proof
sealing compound
or plumber's
tape.
Never store a spare tank under or near your grill.
IMPORTANT:
When connecting
or replacing
gas pipe or fittings,
all joints must be
sealed with approved
leak-proof
sealing compound
or plumber's
tape. After making
connections,
check all joints for leaks using a soapy water solution
and a brush.
WARNING:
Never use an open flame to test for gas leaks. Use of an open flame could
result in a fire, explosion
and bodily harm.
9
Advertisement
