Using Hp Quick Launch Buttons - HP EliteBook 2740p User Manual
Hide thumbs
Also See for EliteBook 2740p:
- Maintenance and service manual (117 pages) ,
- Driver installation (20 pages) ,
- Overview (16 pages)
Table of Contents
Advertisement
Using HP Quick Launch Buttons
The HP Quick Launch Buttons enable you to quickly open programs, files, or Web sites you use
frequently. You can use the factory settings, which are described in the following table. Or you can
reprogram the buttons by opening the Q Menu in the Quick Launch Buttons control panel.
The Quick Launch Buttons include the QuickWeb button (1) and the QuickLook button (2).
The following table describes the factory settings for the Quick Launch Buttons.
NOTE:
Button functions vary, depending on the software installed on your computer.
Component
(1)
QuickWeb button
(2)
QuickLook button
Description
●
When the computer is off, press the button to open HP
QuickWeb.
●
When the computer is on, press the button to open the
default Web browser.
●
When the computer is off, press the button to open HP
QuickLook.
●
When the computer is on, press the button to open Software
Setup.
NOTE:
If Software Setup is not available, the default Web
browser opens.
Using HP Quick Launch Buttons
57
Advertisement
Table of Contents
Need help?
Do you have a question about the EliteBook 2740p and is the answer not in the manual?
Questions and answers
I want to enable UEFI settings so my laptop(HP elite book 2740p) can access the file and boot from it but it keeps showing me an error message even after setting it severally
To enable UEFI settings on your HP EliteBook 2740p and boot from a file without errors, follow these steps:
1. Enter BIOS Setup: Restart the laptop and press F10 repeatedly during startup to access the BIOS (HP F10 Setup).
2. Enable UEFI Boot Mode:
- Navigate to the Boot Options section.
- Look for UEFI Boot Mode and set it to Enabled (it is disabled by default).
3. Configure Boot Order:
- In the Boot Order settings, ensure that the desired boot device is prioritized.
- If booting from a USB or SD card, ensure USB Boot or SD Boot is enabled.
4. Save and Exit:
- Press F10 to save changes and exit the BIOS.
5. Boot from a File:
- Restart the laptop and enter the boot menu (usually by pressing F9 at startup).
- Select Boot from EFI file and navigate to the appropriate EFI file.
By following these steps, you should be able to enable UEFI and boot from a file without encountering errors.
This answer is automatically generated