Example LAN View Configuration - Group LCONs
Introduction
Example
Configuration -
Parameters and
Tables
Router Interface
Port 5
LAN
LAN
Port
IP Forwarder
- Bridge
- Router
Configuring a Vanguard Router
T0100-01, Revision B
This example highlights how to configure a Vanguard Router to carry LAN traffic
over a WAN using LANView. Group LCON will be used.
Figure 3-3 below illustrates the functional diagram of the Vanguard Router and the
important parameters that should be configured. In this example, Node 100 is
configured to initiates calls to Node 200 and Node 300. Only one router interface is
configured at Node 100 and the LAN Connection Type is set to GROUP.
Note
Default values are used for parameters not specified in the table.
Node 100
LCON 1
FRI-1S1
5
1
LCON 2
FRI-1S2
WAN Adaptor
Figure 3-3. LANView Functional Diagram - Group LCON
Port 1
FRI
WAN
Port 1
WAN Port
Configuration
Port 5
Port 1
Node 200
LAN
Port 5
Node 300
Port 1
LAN
3-7
Release 5.4