GE PKD915 Owner's Manual page 11

Read these instructions completely and carefully.
GEAppliances.com
Advance Planning
, The warming drawer may be installed directlg into a wall or
wall oven cabinetry.
, The warming drawer may be installed below a countertop, a
single or double oven and side by side using 2 drawers.
, When installing warming drawer with a cooktop allow a 2"
minimum from bottom of a cooktop burner box to top of
cutout.
, Electricalpower cord is located on the right side of the
warming drawer. Locate the outlet within reach of the
56" long power cord in adjacent cabinet, within 42" of the
right side or 16" from the left side of the cutout. A recessed
receptacle can be installed on the right side of the cutout, 7"
maximum from the back of the cabinet.
Grounding the Appliance
IHPORTANT--{Pleaseread carefully)
FOR PERSONAL SAFETY,THIS APPLIANCE MUST BE
PROPERLYGROUNDED.
Do not use an extension cord or adapter plug with this
appliance. Follow National Electrical codes and ordinances.
This warming drawer must be supplied with 120V, 60Hz,and
connected to an individual, properly grounded branch circuit,
and protected bg a 15 or 20 amp circuit breaker or time delag
fuse.
ii_ii_iiiiiiiiii_ii !iiiiii]i i ii
Recessed
_ eceptade 7"
mo×. from rear
/ / on right side
Drill 1½" hole for
power cord for
left or right side
outlet location
Rating plate
, A properly grounded 3-prong receptacle should be located
within reach of the drawer's 56" long power cord.
Locate the receptacle in an adjacent cabinet.
-within 42" of the right side or,
-within 16"of the left side or
--A recessed receptacle may be located on the right side of
the cutout, 7" maximum from the back of the cabinet. In this
location, the excess power cord should be coiled and taped
to the right side of the unit.
IMPORTANT--IPIease read carefully)
The power cord of this appliance is equipped with a 3-prong
(grounding) plug that mates with a standard 3-prong grounding
wall receptacle to minimize the possibility of electric shock. The
customer should have the wall receptacle and circuit checked
by a qualified electrician to make sure the receptacle is properly
grounded and has the correct polarity.
, Where a standard 2-prong wall receptacle is encountered, it
isthe personal responsibility and obligation of the customer
to have it replaced with a properly grounded 3-prong wall
receptacle.
Do not, under ong circumstances, cut or remove the third
(ground) prong from the power cord.
DO NOT USEAN EXTENSION CORD.
11