Whirlpool 1188927 Use And Care Manual page 7

Option 2-- Connect Drain Hose
If you plan to run your dehumidifier continuously, you may want
to attach a garden hose to the drain hose connector.
1. Use a flat-blade screwdriver to gently pry out the drain hose
connector cover. Discard the cover.
J
J
B
A
/
A. Drain hose connector cover
B. Bucket
2. Remove bucket.
3. Attach a garden hose to drain hose connector on the inside of
the dehumidifier. Hand tighten.
A
B
A. Garden hose
B. Drain hose connector
4. Place the other end of garden hose into a floor drain. Check
to see that the hose lies flat and is in the drain.
5. Reinstall bucket.
NOTES:
• To use the bucket without the garden hose, remove the
garden hose. Then reinstall bucket.
• The bucket must be installed and properly aligned for the
dehumidifier to operate with or without a garden hose
connected.
When your dehumidifier is operating normally, you may hear
sounds such as:
• Compressor sounds, which may be loud. This is normal.
• Clicking sounds when the dehumidifier or compressor turns
off and on, and when the Automatic Shutoff Switch is
working.
• Air movement from the fan.