Advertisement
TOOLSTOBAGE
NOTE:Unplugcleaner before changingpaper bag. Cleanermust havepaper bag in place at all times.
Pushbackdirtwindowflap.Aligntabs
Place the hose into the
ATTACH TOOLS:(A) - Slide the dust
onclear dirt passagewindowwith the
two side hose clips,
brush onto the post on the tool caddy
slots onthe lower hosecuff. Pushand
with bristles facing out. Push down to
turn to lock into place (inset).
secure.(B)- Slidethe extensionwand into
the roundslot on the right, (C)- Slidethe
crevicetool into the roundslot on the left.
WARNING:FULLY ASSEMBLE CLEANER BEFORE OPERATING.
NOTE:Paperbag must be properly installedbefore operating.
QUICK CORDRELEASE
CORDGUIDE
ON/OFF SWITCH
TOREMOVE
Take front
panel off by
squeezingfront panel release
lever towards you.
TOiNSTALL
Graspcardboardcollar of paper bag
with both hands andpull past raised
locking tabs on the dirt tube.
Disposeof old paper bag.
IMPORTANT:EXTENDBAG AWAY
FROMHOLE BEFORE INSTALLING.
Press in opening to clear paper
away from hole.
To releaseyour cord,turn the
top cord hook to the left or
right.
FLOOR/CARPET CLEANING
Keepthe cord out of the way
whileyou vacuumbysnapping
it into the cord guide on the
backof the handle.
Plug cord into electrical outlet.
Steponthe power switch to turn
on the cleaner. Switch is grey
and located on the base of the
unit.
ABOVE FLOOR CLEANING
Pushcardboardcollarpast raisedlocking tabs on the dirt tube
with both hands(Diagram1). The bottomof the bagshouldbe
resting on the postslocated insidethe right and leftof the bag
chamber (Diagramla). Be sure paper bag is fully extended
and tucked in at the top and bottom (Diagram 1b).
Replacefront panel by putting the one bottom
tab in the slot on the vacuura (Diagram2). Close
until it snaps into place (Diagram2a).
WARNING: U NPLUG CLEANER BEFORE CHANGING FILTER.
BAG CHAMBERFILTER(INTERNAL)
Locatedunder the paper bag,
Releasethe handle. With your
foot,
depress the handle
release pedal on the left side
of the base.
Move the handle and adjust it to the
desired position for (A) storing the
upright,(B)operating the cleaner,and(C)
low profile for cleaning under furniture.
NOTE:Youwill need to depress handle
releasepedal again for low profile.
Cleanermust be locked in the
upright position to lift the
rotating brush off the carpet
whencleaning abovethe floor.
Turn cleaner off BEFORE
attachingor removing hose.
Takefront panel off
by squeezing front
panel release lever
towards you.
Lift up on front edge
and pull towards you to
remove.
Brush
or
shake filter debris until
dirt stops falling from
the
filter.
In
some
cases, more or less
cleaning of the filter
may be required.
7
8
Advertisement
