About Memory; Recalling Data; Clearing Data - A&D UA-621 Instruction Manual

The device automatically stores up to thirty blood pressure and pulse
measurements in memory. Data stored in memory are assigned a data number
in the order of the newest to the oldest. The oldest data displays as "n01". The M
symbol in the upper left corner of the display indicates that you are viewing
previous data stored in memory.

Recalling Data

1. When nothing is displayed, press and hold the
button to display the data number.
START
The data number of the most recent
measurement and the data are displayed.
2. The data are automatically displayed in turn.
3. The display will shut off automatically after all
data is displayed.
Note: If you press the
recalling data, the device starts
measurement.

Clearing Data

Remove the batteries to clear all data. Re-install them again.
If there is no data stored in memory, you will see two 0s displayed
vertically followed by a blinking "A00".

About Memory

button while
START
11
Press and hold