Ribbon Saving Module (B-Ex904-R-Qm - Toshiba B-EX4 SERIES Maintenance Manual

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
4.4 RIBBON SAVING MODULE (B-EX904-R-QM-R)
All the following parts are supplied with the kit. Make sure you have all items shown below.
NOTE: The ribbon saving module is standard on the B-EX4T series.
Solenoid (1 pc.)
Cable Clamp (1 pc.)
1) Remove the side panel (L) from the printer. (Refer to section 3.2.)
2) Remove the operation panel ass'y from the printer. (Refer to section 3.4.)
3) Fit the three locking supports into the RSV PC board.
RSV PC Board (1 pc.)
Locking Support (3 pcs.)
Locking Support
4.4 RIBBON SAVING MODULE (B-EX904-R-QM-R)
Insulation Tape
RSV PC Board
4-20
Solenoid Harness (1 pc.)
• Installation Manual (1 copy)
• SM-4x8 Screw (2 pcs.)
EO18-33027