PAC RP4-CH11 Manual

Introduction & Features
The RP4-CH11 interface allows the replacement of a factory radio in select Chrysler/Dodge/Jeep vehicles with MSCAN or
LSFT-CAN databus radios. Using this interface will retain factory features such as steering wheel controls (SWC) vehicle
entertainment system (VES) and the factory audio amplifier whenever the original radio is removed. The RP4-CH11 also
provides data bus driven outputs such as retained accessory power (RAP), vehicle speed sensor (VSS), illumination,
reverse trigger and parking brake.
Important Notes
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
2. When the interface is first plugged into the vehicle the LED will flash indicating the auto detect sequence. Once the CAN-BUS
speed is detected the LED will illuminate and should be on at all times when the interface is on. The LED will also flash whenever
a SWC button is pressed
3. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions to different buttons. The SWC can always be restored to default settings by pressing
and releasing the program button on the side of the interface once and waiting 7 seconds for the LED to flash 4 times.
Wiring Connection Chart
Interface Connector
Red / White P.B. Output (-)
Purple / White VSS Output
Blue / White Amp Turn On Input
Red Acc. Output (1 amp)
Orange / White Illum. Output (+)
Green Reverse Output (+)
Illustration / Schematic
Vehicle Connector
See above chart for
wire color description.
Pacific Accessory Corporation
Pacific Accessory Corporation
Vehicle Connector
Yellow
Black
Blue
White
White / Black
Grey
Grey / Black
Green
Green / Black
Purple
Purple / Black
Wiring
Interface Connector
See above chart for
wire color descriptions.
| Santa Ana, California 92705 | Ph. 866-931-8021 | support@pac-audio.com
®
Radio Replacement & Steering Wheel Control Interface
Battery +12v
Ground
Antenna On Input
Front L + input
Front L - input
Front R + input
Front R - input
Rear L + input
Rear L - input
Rear R + input
Rear R - input
Pacific Accessory Corporation
©2011 Pacific Accessory Corporation
www.pac-audio.com
for Chrysler/Dodge/Jeep Vehicles
SWC Connector
Blu/Yel
3.5mm Jack
x4
SWC Connection
SWC Connection
RP4-CH11
Kenwwod, Newer
JVC, OEM or
Blaupunkt
Alpine, JVC,
Clarion, Pioneer,
Sony, Valor, Boyo,
Dual, Visteon or
Advent
See above chart for
different radio type
connections
Rev. 112811
Page 1