GE JP340 Installation Instructions Manual
GE JP340 Installation Instructions Manual

GE JP340 Installation Instructions Manual

30"
Hide thumbs Also See for JP340:

Advertisement

Available languages

Available languages

I Iinstallation
130" Electric Cooktop
nstructions
PP,12,
PP932,
PP,42,
PP945, PP950
I[_
"If you have questions,
call 800.GE.CARES
or visit our website
at: ge.com"
I
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
• IMPORTANT - Save t hese
instructions
for local
inspector's
use.
• IMPORTANT - Observe all
governing
codes
and ordinances.
• Note to Installer
- Be sure to leave these
instructions
with
the Consumer.
• Note to Consumer
- Keep these
instructions
for future
reference.
• Product
failure
due to improper
installation
is not covered
under
the Warranty.
_IWARNING
-
This appliance
must
be properly
grounded.
• ATTENTION
INSTALLER -
ALL COOKTOPS
MUST
BE HARD WIRED
(DIRECT
WIRED)
INTO AN APPROVED
JUNCTION
BOX. A "PLUG
AND
RECEPTACLE"
IS NOT PERMITTED
ON
THESE PRODUCTS.
• Proper installation
is the responsibility
of the installer
and product
failure due to
improper
installation
is NOT covered
under
warranty.
MATERIALS
YOU WiLL NEED
Junction
Box
Wire Nuts
TOOLS YOU WiLL NEED
Pencil
Saber Saw
Phillips
Head
Screwdriver
Ruler or Straightedge
1/8" Drill Bit & Electric
or Hand Drill
Safety
Glasses
PARTS INCLUDED
4 Screws
Foam Tape
(WB1X1137)
2 Hold Down
Brackets
31-10637-3
(07-07 JR)
1

Advertisement

Table of Contents
loading

Summary of Contents for GE JP340

  • Page 1 I Iinstallation nstructions 130" Electric Cooktop PP,12, PP932, PP,42, PP945, PP950 "If you have questions, call 800.GE.CARES or visit our website at: ge.com" BEFORE YOU BEGIN MATERIALS YOU WiLL NEED Read these instructions completely and carefully. • IMPORTANT - Save t hese...
  • Page 2: Important Safety Instructions

    Installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY ELECTRICAL REQUIREMENTS • For Personal Safety, remove house fuse This appliance must be supplied with or open circuit breaker before beginning proper voltage and frequency, and connected installation. Failure to do so could result to an individual, properly...
  • Page 3: Pre-Installation

    Installation Instructions PRE-INSTALLATION CHECKLIST - WARNING - The electrical power ChC j Remove Installation Instructions from literature pack and read them carefully to the cooktop supply line must be shut off before you begin. while connections are being made, Failure to do so could result in serious injury or death.
  • Page 4: Preparing The Opening

    This cooktop must be protected with not less kit may be ordered from your GE Dealer. than 1/4" insulating millboard covered with sheet metal not less than 0.0122" thick. Make sure the wall coverings,...
  • Page 5: Installing The Cooktop

    Installation Instructions INSTALLING THE COOKTOP INSTALLING ATTACH FOAM TAPE JUNCTION Apply the foam tape around the outer edge of the glass. Do not overlap the foam tape. Install an approved junction box where it will be easily reached through the front of the Bottom of Cooktop...
  • Page 6: Insert Cooktop Into Cutout

    Installation Instructions INSTALLING THE COOKTOP (CONT.) INSERT COOKTOP ATTACH HOLD DOWN INTO CUTOUT BRACKETS TO CABINET Insert the cooktop centered into the cutout Open the cabinet door and screw the hold down brackets to the cabinet sides with opening. Make sure the front edge of the countertop...
  • Page 7 Installation Instructions INSTALLATION--ELECTRICAL CONNECTIONS When making the wire connections, Once the connections are made, secure the entire length of conduit provided. wires together using wire nuts. The conduit must not be shortened. With the cooktop in place, open the front of the cabinet door.
  • Page 8: Pre-Test Checklist

    Installation Instructions CHECKLISTS OPERATION CHECKLIST PRE-TEST CHECKLIST Remove all items from the top Remove all protective film, if present, and any stickers. of the cooktop surface. Check to be sure that all wiring is secure Turn on the power to the cooktop. and not pinched or in contact with...
  • Page 9 Instrucciones Estufa electrica de 30" de instalacion JP340, JP346, JP356, PP912, PP932, PP942, PP945, PP950 ,,si tiene alguna pregunta, Ilame al 800.GE.CARES o visite nuestro sitio Web en: ge.com" ANTES DE COMENZAR NECESITARA LOS SIGUIENTES MATERIALES Lea estas instrucciones por completo y con cuidado.
  • Page 10: Para Su Seguridad

    Instrucciones de instalaci6n INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD REQUlSITOS ELI:!:CTRICOS • Para su seguridad personal, retire Este aparato debe contar con el voltaje fusibles de su hogar o bien abra el frecuencia adecuados, y debera conectarse cortacircuitos antes de comenzar con la a un circuito derivado...
  • Page 11 Instrucciones de instalacion LISTA DE VERIFICACION PREVIA A LA INSTALACION AADVERTENCIA - La corriente Saque las instrucciones de instalaci6n del paquete de material impreso y lealas electrica a la tuberia de abastecimiento de la cuidadosamente antes de comenzar. estufa debe cortarse durante la realizacion conexiones.
  • Page 12 Puede solicitar este juego a su distribuidor de 0.0122" de grosor. de GE. _1 DIMENSIONES GENERALES Asegurese que las cubiertas de las DE LA ESTUFA paredes, el mostrador y los gabinetes alrededor...
  • Page 13 Instrucciones de instalaci6n INSTALACION DE LA ESTUFA _-I INSTALACION DE LA CAJA APLIQUE LA CINTA DE ESPUMA DE EMPALMES Aplique la cinta de espuma alrededor borde externo del vidrio. No aplique Instale una caja de empalmes aprobada exceso de cinta de espuma. un lugar de facil acceso a traves...
  • Page 14 Instrucciones de instalaci6n INSTALACION DE LA ESTUFA (CONT.) INSERTE LA ESTUFA EN 1-_ SUJETE LAS ABRAZADERAS EL AREA CORTADA DE MONTAJE AL GABINETE Inserte la estufa centrada en el area cortada. Abra la puerta del gabinete y atornille Asegurese de que el borde frontal del mostrador las abrazaderas de montaje...
  • Page 15 Instrucciones de instalaci6n INSTALACION--CONEXIONES ELECTRICAS Cuando realice las conexiones de cables, Una vez que se hayan realizado utilice toda la extensi6n del conducto conexiones, fije los cables con las incluido. El conducto no debe reducirse. tuercas para cables. Con la estufa colocada en su lugar, abra...
  • Page 16 Instrucciones de instalaci6n LISTAS DE VERIFICACION _-_ LISTA DE VERIFICACION LISTA DE VERIFICACION PREVIA DE OPERACION Retire todos los objetos que se Retire toda la pelicula protectora, si la hay, y las calcomanias. encuentren sobre la superficie de la estufa. Verifique que todos los cables...

Table of Contents