Charging And Recharging The Batteries - VTech InnoTab 3S The Wi-Fi Learning Tablet User Manual

The wi-fi learning tablet
Hide thumbs Also See for InnoTab 3S The Wi-Fi Learning Tablet:
Table of Contents

Advertisement

Charging and Recharging the Batteries

The rechargeable batteries should be fully charged before the first use. To charge
and recharge the batteries, please follow the instructions below.
1. Make sure the battery packs are installed in the tablet.
2. Plug one end of the AC adapter into the power jack on the InnoTab
plug the other end into a wall outlet.
Note: The AC adapter is not a toy and should only be handled by an adult.
3. You can continue to use the InnoTab
the batteries will not charge while the InnoTab
turn the power off and leave the tablet connected to a wall outlet to charge it.
4. The green light on the tablet will flash to indicate charging is in progress.
When the batteries are fully charged the light will turn off. A full charge takes
about 4.5 hours with the AC adapter that's included in the package.
Note: If the green light on the tablet flashes very quickly during charging, the
battery packs may not be connected properly. Please reinstall the battery
packs and try again.
Important Notes:
• Make sure the InnoTab
• The tablet will charge at temperarures between 41°F~95°F(5°C~35°C).
If the tablet is not charging properly, please move it to a location with a
suitable temperature.
• Battery removal and replacement should only be done by an adult.
• Keep the connector pins on the InnoTab
battery packs clean for optimal performance.
• Disconnect the tablet from the AC adapter and remove the battery packs
before cleaning.
• For best results, please use the AC adapter that is included with this package.
Warning : Do not allow any metal objects to touch the metal contacts on the battery
packs or the contact pins on the
Battery Notice
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc), or
rechargeable (Ni-MH).
• Only batteries of the same or equivalent type as recommended are to be used.
• Always insert batteries properly matching the plus (+) and minus (-) signs.
5
• Do not short-circuit the supply terminals.
3S while the AC adapter is connected, but
®
3S is turned off before charging.
®
InnoTab
3S is on. When you're done playing,
®
3S and the metal contacts on the
®
3S
®
.
3S and
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the InnoTab 3S The Wi-Fi Learning Tablet and is the answer not in the manual?

Questions and answers

Table of Contents