Table of Contents
Advertisement
Appendix A Messages
No
39
Role not available for fiber adapters
40
Can't judge T or SX !!
DDI_DETACH busy, because fjla is
41
active!
42
can't la attach fjgiX.
fjgi_la_mlist: pAC (pVAC) member is
43
wrong
44
(Other messages)
*1:
This
appears
PRIMEPOWER250/450 secondary LAN port is used in 1000Mbps.
The Machine Administration function included in Enhanced Support Facility may report messages
listed in Table A.1.2.
Message
fjgi_device_check: fjgi_hw_deinit
failed !
62
Message
only
when
Table A.1.2 Machine Administration Reported Messages
An error occurred during
initialization of the adapter.
Cause
Role setting is no supported
with
PW008GE4/PW0G8GE1/SE0X7GD2X
.
The adapter type cannot be
recognized.
LinkAggregation member
interfaces cannot be
detached.
LinkAggregation setup for
fjgiX failed.
Abnormal response was
returned to the fjla stat
command.
There is a possibility of
driver internal bug or
hardware failure.
PW008GE5/PW0G8GE2/SE0X7GD1X/PW008QG1/SE0X7GQ1X
Meaning
Workaround
Remove Role_A parameter
in the fjgi.conf file.
Check whether the system
is supported. Since
there is possibility of
hard abnormalities when
the system is supported,
please replace the
adapter.
Perform DDI_DETACH after
terminating the
LinkAggregation
function.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
The internal group table
may be corrupt. Please
report this error to your
service provider.
Report the error to your
service provider.
or
Workaround
A driver may be the number
of versions which is not
supporting this adapter.
Please apply the
indispensable patch
indicated to Installation
Guide. Since there is
possibility of hard
abnormalities when a
problem still is not
solved, please replace the
adapter.
Advertisement
Table of Contents
