Installation Below A Countertop - GE CW9000SDSS Use And Care Manual

Installation of the warming drawer.
Read these instructions completely and carefully.
Remove Packaging and Parts
Parts provided: 4 Wood screws
Place carton on a flat surface.
Open one end of the carton and lift off the top piece.
Lift the warming drawer up and out of the carton.

Installation Below a Countertop

Install 2x4 or 2x2
anti-tip block against
rear cabinet wall 9"
from floor to bottom
of block
Electrical
outlet 16" max.
from left side
CAUTION
IN CANADA THIS DRAWER IS NOT
APPROVED FOR INSTALLATION
UNDER A COOKTOP.
When installed, the front face of the warming drawer will be
nearly flush with cabinetry doors or drawer fronts.
Drawer overlaps will conceal cut edges on all sides of the
opening.
The rough opening for the drawer must be:
23 " minimum from inside back to front of cabinet
1 2
frame.
25 " for 27" wide models
1 2
28 " for 30" wide models.
1 2
9 "
1 4
5" minimum above floor or 1" above toekick. 23
to bottom of cutout is recommended for under countertop
installation.
12
Electrical outlet 42"
Electrical outlet
max. from right side
flush with side of
cabinet 7" max.
9"
Solid barrier
1/4" Air gap
"
23 Min.
1 2
Install a solid barrier
and a 1/4" min. air
gap above warming
drawer
" from floor
1 4
Place the drawer on top of the shipping carton to protect
the drawer front and the finished flooring.
Remove all packing materials and tape.
Locate package containing 4 wood screws and set aside.
Install a solid barrier below
7"
a cooktop (see Note)
*NOTE: When installing the warming drawer below a cooktop, a solid
barrier must be installed at least 1" from the lowest point of the bottom
of cooktop burner box to the top of cutout. Use any solid material such as
1/4" thick plywood. Allow at least 1/4" air gap between the barrier and the
top of the warming drawer. See label on top of the wa rming drawer for
approved cooktop models.
Installation below a cabinet drawer:
The warming drawer may be installed beneath a cabinet
drawer. In this installation, a solid barrier should be installed
above the warming drawer to block access. Use any solid
material such as 1/4" thick plywood. Allow at least 1/4" air
gap between the barrier and the top of the warming drawer.
Observe the 5" min. above the floor or 1" above the toekick min.
installation height.
NOTE: If you are installing in frameless cabinets, it may be
necessary to install 1/2" wide cleats to accept drawer mounting
screws. See drawer to find exact locations of mounting screws.
When installed under a cooktop:
Warming drawers are suitable for installation below only certain
specified cooktop models. See the label attached to the top of
the warming drawer for suitable models. A solid barrier and air
gap between cooktop and warming drawer is required. See
Note above.
1 " Cabinet top
1 2
25"
1" Min.*
36"
Countertop
height
9 "
1 4
Dimension A
27 " Drawer
"
25
1 2
30 " Drawer
"
28
1 2