Replacing An Interface Cable; Replacing Cables And Batteries In Cordless Systems; Replacing An Interface Cable In A Base - Honeywell 1900GHD-2 User Manual

Replacing an Interface Cable

1. Turn the power to the host system
OFF.
2. Disconnect the scanner's cable
from the terminal or computer.
3. Locate the small hole on the back
of the scanner's handle. This is
the cable release.
4. Straighten one end of a paper
clip.
5. Insert the end of the paper clip
into the small hole and press in.
This depresses the retention tab,
releasing the connector. Pull the
connector out while maintaining
pressure on the paper clip, then
remove the paper clip.
6. Replace with the new cable.
Insert the connector into the opening and press firmly. The connector is
keyed to go in only one way, and will click into place.
Replacing Cables and Batteries
in Cordless Systems

Replacing an Interface Cable in a Base

1. Turn the power to the host system
OFF.
2. Disconnect the base's cable from the
terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while
maintaining pressure on the
connector release clip.
5. Replace with the new cable.
Insert the connector into the opening
and press firmly. The connector is
keyed to go in only one way, and will
click into place.
Cable
Release
13 - 3