Installation: Power/Data Cable - Navman TRACKFISH 6500 Installation And Operation Manual

18-4 Installation: Power/data cable

The power/data cable has a black locking collar and flying leads.
1 Wire the TRACKFISH for auto power to have the TRACKFISH turn on with the boat's ignition
switch or to to record engine hours or if the TRACKFISH must add up the total fuel used (for
example if Navman petrol/gasoline fuel sensors are installed or if SmartCraft is installed without
fuel tank level sensors). Otherwise wire for basic power (for more information, see section 2-2).
Basic power
Black
Auto power
During setup, set up Auto power off (see sections 2-2 and 17-1)
Black
2 Wire any external alarm beepers or lights.
The alarm output switches to ground to
sound the alarm. If the current is more than
200 mA, fit a relay.
3 Connect the power/data cable to the black
display unit connector; turn the collar to
lock the connector.
74
Power/data cable
Red
Yellow
Black
Power/data cable
Yellow
Red
Black
NAVMAN
Fuse 2A
Fuses 2A
Black
TRACKFISH 6500 Installation and Operation Manual
Main switch
12/24 V DC
Ignition
Ignition switch
Main switch
12/24 V DC
Power/data cable
Red
Green
External beepers or
lights