Loading And Unloading Film - Canon EOS Rebel T2 SERIES' EOS 300X SERIES Instruction Manual

=Loading and Unloading Film

Loading Film
After you load the film, the camera first winds the entire roll onto the
camera's take-up spool. With DX-coded film, the camera
automatically sets the film's ISO speed. Then each time a picture is
taken, one frame of film is rewound back into the film cartridge. The
frame counter shows always number of shots remaining.
Wrong
1 Turn the Mode Dial to any
setting except <:>.
2 Open the back cover.
•
Slide down the back cover release
lever and open the back.
3 Insert the film cartridge at a
slight angle.
4 Align the film leader edge with
the <§> mark.
•
Hold down the film cartridge while
pulling out the film leader. If you
pull out the film leader too much,
rewind it back into the film
cartridge.
5
Close the back cover.
•
Close the back cover until it snaps
shut.
Film prewind will start and there will
s
be a shutter-release sound about
10 sec. later. The <=> icon and
frame count will also be displayed
on the LCD panel.
During the film prewind, the ISO
s
speed will be displayed on the LCD
panel.
15