Packard Bell Grafite & Carbon Disassembly Manual

Packard Bell Grafite & Carbon Disassembly Manual

Advertisement

Packard Bell
Grafite & Carbon
Disassembly Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Grafite & Carbon and is the answer not in the manual?

Questions and answers

Summary of Contents for Packard Bell Grafite & Carbon

  • Page 1 Packard Bell Grafite & Carbon Disassembly Manual...
  • Page 2: Table Of Contents

    For More Information ......................2 Technician Notes......................... 2 Disassembly........................2 Reassembly ........................2 Required Tools ........................2 Front Cover ........................3 Top Cover .......................... 3 Hard Disk Drive........................4 I/O Board.......................... 5 Notice ..........................6 Packard Bell Grafite & Carbon Disassembly Manual...
  • Page 3: About This Guide

    This guide contains systematic disassembly instructions for the Packard Bell Grafite & Carbon. The instructions are illustrated where necessary with images of the part that is being disassembled. Packard Bell B.V. reserves the right to make changes to the Grafite & Carbon without notice. For More Information For more information about the Packard Bell Grafite &...
  • Page 4: Front Cover

    To remove the top cover, first remove the front cover (see Front Cover on page 3) and then perform the following steps: 1. Turn the device over so the top is facing up. Packard Bell Grafite & Carbon Disassembly Manual...
  • Page 5: Hard Disk Drive

    Note: One of the screws on each side of the hard disk drive holds a spacer clip. Fig. 3 Removing the hard disk drive screws. Note: In Fig. 3 only 2 screws are visible; the other 2 screws are located on the other side of the hard disk drive. Packard Bell Grafite & Carbon Disassembly Manual...
  • Page 6: I/O Board

    1. Remove the 2 screws securing the I/O board. Fig. 5 Removing the I/O board. 2. Disconnect the LED cable from the header on the I/O board (see Fig. 5 3. Carefully take out the I/O board from the device. Packard Bell Grafite & Carbon Disassembly Manual...
  • Page 7: Notice

    This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from Packard Bell B.V. PACKARD BELL B.V. SHALL NOT BE HELD LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN;...

Table of Contents

Save PDF