Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Phonic Helix Board 17
Summary of Contents for Phonic Helix Board 17
-
Page 1: Helix Board
Helix Board 17 COMPACT MIXER WITH USB INTERFACE English... -
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable. -
Page 3: Table Of Contents
Precautions ..........................1 1 Operating System ........................11 APPLICATION ..........................12 DIGITAL EFFECT TABLE ......................13 SPECIFICATIONS ........................14 BLOCK DIAGRAM........................16 DIMENSIONS..........................17 Phonic reserves the right to improve or alter any information supplied within this document without prior notice. V1.1 11/14. 2005... -
Page 4: Introduction
3-band EQ with swept mid-range plus low cut on each ous Phonic products have shown; with more than a few mono channel refi nements, of course. The Helix Board 17 features full 2 Aux sends, one with Pre/Post switch gain ranges, amazingly low distortion levels, and incredibly... -
Page 5: Getting Started
Turn the power switch on. Pre/Post button on the CTRL RM section will send the Insert the provided USB cord into the Helix Board 17's pre-fader signal of the activated channel to the Control USB jack, and your personal computer's USB jack. -
Page 6: Making Connections
These outputs will accommodate RCA Stereo Channels cables, able to be fed to a variety of The Helix Board 17 features a few balanced stereo chan- recording devices. Also included is a nels, thrown in for maximum fl exibility. Each of these stereo mini stereo jack for the addition of channels features two 1/4"... -
Page 7: Controls And Settings
11. Channel Inserts with a 44.1 kHz sampling rate) output jack allows users Located on the rear of the Helix Board 17, the primary use to connect their Helix Board 17 mixer to a multitude of for these TRS phone jacks is for the addition of external... -
Page 8: Channel Controls
Also included is a Pre/Post button (for AUX 1), which alternates the feed to the AUX mixing bus between a post and pre-fader feed. HELIX BOARD 17... -
Page 9: Parameter Control
Peak indicator does not light up at all. This will ensure a greater dynamic range for audio. 37. Effect On Button and Indicator This button is pushed to turn the corresponding effect panel on or off. When the effect processor is turned on, the corresponding LED illuminates. HELIX BOARD 17... - Page 10 Control Room/Phones mixing bus, whereas the lower button (“to L/R”) sends the signal to the Main L-R mixing bus. These buttons can, of course, be used simultaneously, feeding the signal to both the Control Room/Phones and Main L/R mixing bus. HELIX BOARD 17...
-
Page 11: Usb Interface
Digital Workstation software to use the signal from the USB device in any way you desire. The USB interface also returns the audio signal from your computer back to the 2T Returns of the Helix Board 17, the signal of which is controlled by the 2T return control. If there are both digital and analog signals being sent to the 2T return, the two signals are combined and controlled simultaneously by the 2T return control. -
Page 12: Application
Application On the following couple of pages you will fi nd a wide range of possible uses for the Helix Board 17 mixers. Of course these are far from the only applications that can be attributed to the mixers’ use; however they should give you an idea of the possible uses that the various inputs and outputs have. -
Page 13: Digital Effect Table
Allows you to select the delay time by clicking a button twice or by use of a TAP DELAY footswitch. The amount of feedback 100 ms is adjusted using the PARAMETER Delay Time (600bpm) – 2690 ms control. (22.3bpm) HELIX BOARD 17... -
Page 14: Specifications
Channels 1-4 unit gain; EQ fl at; all channels on main mix; channels 1/3 as far left as possible, channels 2/4 as far right as possible. Reference=+6dBu) Master @ unity, channel fader down -86.5 dBu Master @ unity, channel fader @ unity -84 dBu HELIX BOARD 17... - Page 15 Hi EQ 12 kHz Low cut fi lter 75 Hz (-18 dB/oct) Built-in Power Supply 100-240 VAC, 50/60 Hz Weight 9.25 lbs (4.2 kg) Dimensions (WxHxD) 300 x 104.5 x 340 mm (11.8” x 4.1” x 13.4”) HELIX BOARD 17...
-
Page 16: Block Diagram
BLOCK DIAGRAM HELIX BOARD 17... -
Page 17: Dimensions
DIMENSIONS All measurements are shown in mm/inch HELIX BOARD 17... - Page 18 Phonic, at its option, shall repair or replace the defective unit covered by this warranty. Please retain the dated sales receipt as evidence of the date of purchase.
Need help?
Do you have a question about the Helix Board 17 and is the answer not in the manual?
Questions and answers