OWNER’S GUIDE READ AND SAVE THESE INSTRUCTIONS Record Model No. and Serial No. of this dehumidifier in space provided below. These numbers are printed on the nameplate located behind the bucket. M odel No. ___________________________________________________ Serial No. ____________________________________________________ IM PORTA NT: Keep a copy of your bill of sale. The date on the bill establishes the warranty period should service be required.
Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this war- ranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this war- ranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer.
IM PORTA NT: 1. Dehumidifier m m ust b b e o o perated i i n a a n e e nclosed a a rea t t o b b e m m ost e e ffective. Close a a ll d d oors, w w indow s, a a nd o o ther o o utside o o penings t t o t t he r r oom. T T he...
OPERATION & FEATURES Allow the unit to reach room temperature before operating. To begin operating the dehumidifier, follow these steps: 1. Plug the power cord into a properly grounded 110/120 volt AC outlet. Note the POWER indicators will illuminate. 2. To turn the unit on press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high fan speed.
Page 5
3. After a few days when the Relative Humidity has declined, press the HUMIDITY button to choose either 50%, 60% or 70%, so the room is kept at a comfortable concentration. The unit will cycle on and off keeping the desired level of comfort.
REMOVING COLLECTED WATER 1. Emptying the Bucket: a. When the bucket is full the unit will shut down and the BUCKET FULL indicator light will illuminate. b. Do not move the unit at this point otherwise water may spill on the floor. c.
Dust cabinet with an oil-free cloth, or using a damp cloth. b. Vacuum grill using brush attachment. 3. Water Bucket a. Clean bucket with warm water and detergent. FAULT CODES If the display reads "F1" or "F2", a sensor has failed. Contact your Authorized Frigidaire Service Center. fig.2 fig.3 fig.4...
Dehumidifier is not turned on. Turn unit on. W indows or doors near dehumidifier are open to outdoors. Close all windows or doors to outside. Area to be dehumidified is too large. Check with your dealer to see if capacity is adequate.