Canon iP4700 SERIES On-Screen Manual page 46

from being ejected properly.
5.
Install the new ink tank.
Insert the front end of ink tank into the Print Head at a slant.
(1)
Make sure that the position of the ink tank matches the label.
(2) Press the mark
place.
Make sure that the ink lamp lights up red.
Important
You cannot print if the ink tank is installed in the wrong position. Be sure to install the ink tank in
the correct position according to the label on the Print Head Holder.
You cannot print unless all the ink tanks are installed. Be sure to install all the ink tanks.
6.
Close the Top Cover.
Note
If the Alarm
lamp still flashes orange after the Top Cover is closed, refer to "Alarm Lamp
Flashes Orange" in " Troubleshooting
When you start printing after replacing the ink tank, the printer starts cleaning the Print Head
automatically. Do not perform any other operations until the printer completes the cleaning of
the Print Head. The
Power
If printed ruled lines are misaligned or the print head position is misaligned, adjust the print head
position.
See Aligning the Print Head
The printer may make noise during operation.
(Push) on the ink tank until the ink tank snaps firmly into
" of the on-screen manual: Advanced Guide .
lamp flashes green while cleaning.
.