Your product is protected by this warranty Your appliance is warranted by Electrolux. Electrolux has authorized Frigidaire Consumer Services and their authorized servicers to perform service under this war- ranty. Electrolux authorizes no one else to change or add to any of these obligations under this warranty. Any obligations for service and parts under this war- ranty must be performed by Frigidaire Consumer Services or an authorized Frigidaire servicer.
On some models, remove the filter and look at the bottom edge of the air conditioner behind the front grille for the model and serial numbers. Reading these numbers may be easier by using a flashlight or by removing the cabinet front as instructed under “Care...
• If the air conditioner is to be installed in a window, you will probably want to clean both sides of the glass first. If the window is a triple-track type with a screen panel included, remove the screen completely before installation.
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance. To begin operating the air conditioner or heater, follow these steps: 1. Plug in the air conditioner. (To prevent electrical hazards, do not use an extension cord or an adapter plug.) 2. Press “On/Off” button to turn unit on.
Page 6
Air Conditioner Features (continued) TO TURN UNIT ON: TO CHA NGE TEM PERATURE SETTING: Note: Tap or hold either up( ^ ) or down(v) button until the desired temperature is seen on display. This temperature will be automatically maintained anywhere between 60F (16C) and 90F (32C) for cooling mode. The Temperature will be automatically maintained anywhere between 55F (13C) and 80F (27C) for heating mode.
Page 7
Air Conditioner Features (continued) TO OPERATE ON FAN ONLY: Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any fan speed you prefer,EXCEPT AUTO FAN. During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode.
Page 8
Air Conditioner Features (continued) SLEEP FEATURE: The Sleep Mode can be selected with a Heating or Cooling Mode. Note: In this “MODE” the selected cooling temperature will increase by 2 degrees F, 30 minutes after the mode is selected. The temperature will then increase by another 2 degrees F, after an additional 30 minutes.
Air Conditioner Features (continued) TO TURN UNIT OFF: ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should know. • The Remote Control will operate all the control panel features, follow the same instructions.
• Plug in air conditioner. Winter Storage If you plan to store the air conditioner for the winter, cover it with plastic or return it to the original carton. NOTE: To prevent rust or electrical connections from being damaged, store air conditioner in an upright position and a dry place.
Window vibration — poor installation. Refer to installation instructions or check with installer. Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to installation instructions — check with installer. Unit removing large quantity of moisture from humid room. This is normal during excessively...
Need help?
Do you have a question about the THRU-THE-WALL AIR CONDITIONER and is the answer not in the manual?
Questions and answers
How do you remove the front grill to clean unit model FAH08ES1T