Avery Dennison AP5.4 Gen II User And Service Manual page 64

03/10 Rev. 5.05-00
1. Switch printer off.
2. Switch printer on, simultaneously press the Feed+Prog-key until the printer
3. Enter the production code.
Deactivated
Power-up code
User
Supervisor
User auto start
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Mode Key code
User 2x Cut Feed, Online
Supervisor 2x Online, Feed, Cut, 2x Online
Production Cut, Online, Feed, Cut, 3x Online
[5] Permissible key codes.
CAUTION! - The key code "production" allows the access to parameters,
which are used during production to adjust the printer. Input errors to those
parameters can make the printer inoperable or can damage it. For this
reason, the production code may only be applied by trained service
technicians!
Especially service technicians may use the direct access into production
mode, even if the parameter Access authoriz. is set to Deactivated, what
means that no password will be queried at all. To do so, proceed as follows:
type is displayed.
After the printer was powered up, the key code will be queried:
Possible Settings
Password interrogation switched off (default)
Activates the password interrogation directly after switching the printer on.
After the input of a valid key code, the printer switches into offline mode.
Depending on the entered key code, the printer starts in user, supervisor or
production mode.
Activates the password interrogation when accessing the parameter menu.
The printer is in the offline mode after switch-on
Change to the online mode is possible without restriction
To reach the parameters-menu, enter a valid key code
Valid key codes: all
As setting „User", with different valid key codes:
Valid key codes: Supervisor, Production
Printer starts without password interrogation. Only the menus
SERVICE DATA
are accessible.
Info-Printouts & Parameters
Impact
Access only to the submenus
PRINT INFO SERVICE DATA
and
Access to all parameters ex-
cept production parameters
Access to all parameters
PRINT INFO
64
and