Advertisement
Quick Links
Advertisement
Related Manuals for Western Digital WD1002-WAH
Summary of Contents for Western Digital WD1002-WAH
- Page 1 WD1002 WD1003 WD1002 WD1003 USER’S GUIDE 800-1910 (REV. 4-87)
-
Page 2: Hardware Installation
WDl003-WA2 Winchester/Floppy Disk Controller 6. Attach 20-pin data connector to J2 (drive C or 1) for the NOT SUPPORT THIS FEATURE. Primary/secondary I/O address jumper. WD1002-WAH or WD1003-WAH (J4 for WD1002- 1 to 2 Standard factory setting. Jumper in this position NOTE WA2 or WD1003-WA2). - Page 3 WD1002-WA2 JUMPER SETTINGS WD1003-WA2 JUMPER SETTINGS JUMPER POSITION FUNCTION DESCRIPTION No jumper Status Read is non-latched. Dynamic drive select; i.e.. CONNECTS NOTE SELECT = DRIVE BUSY. Used for Compaq 286s. DO NOT MOVE PRIMARY ADDRESS JUMPERS Jumper Standard factory setting. Status read is latched. Static UNLESS YOUR OPERATING...
-
Page 4: Software Installation
SOFTWARE INSTALLATION WD1003-WA2 JUMPER SETTINGS This section contains instructions for preparing (low level PIN CONNECTS DESCRIPTION NOTE format, etc.) your operating system to recognize the Western DO NOT MOVE PRIMARY ADDRESS JUMPERS Digital controller. UNLESS YOUR OPERATING SYSTEM IS CONFIGURED ACCEPT HARD DISK...
Need help?
Do you have a question about the WD1002-WAH and is the answer not in the manual?
Questions and answers