Repeater Mode - TP-Link TL-WR700N User Manual

Figure 2-2 Hardware Installation of the TL-WR700N in Router Mode
1. Connect the WAN port of TL-WR700N to the LAN Port on the DSL/Cable Modem.
2. Connect the WAN port on the DSL/Cable Modem to the wired Internet.
3. Plug the power plug of TL-WR700N in electrical wall socket.
4. Power on the DSL/Cable Modem, PC(s) and notebook(s).

2.3.3 Repeater Mode

TL-WR700N is used to extend the range of wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. The SSID of TL-WR700N should be the same as that of the device you
repeat. To avoid the conflict of DHCP service with front-end devices, the DHCP server is default to
be closed on this mode. If you want to log in the management page, please set your computer's IP
address manually.
TL-WR700N 150Mbps Wireless N Mini Pocket Router
- 7 -