Table of Contents
Advertisement
DKT2404-UDR100 Repeater 04/09
3. At the screw location, use a 3⁄16 inch (4.8 mm) drill bit to make a pilot
hole approximately 1 inch (25.5 mm) deep.
4. Place the wall anchor into the pilot hole and tap it gently with a
hammer until the anchor is flush with the wall.
5. Insert the mounting screw into the anchor, leaving approximately 1/4
inch (6.4 mm) of space between the screw head and the wall.
6. Plug the AC power adapter cable into the repeater.
7. Put the repeater over the screw head and slide it down into place.
8. Plug the AC adapter to a 120 V AC power outlet.
Figure 8 – DKT2404-DECT Repeater Rear View
TOSHIBA
DKT2404-UDR100 DECT Repeater
Installing the Repeater
11 of 16
Advertisement
Table of Contents
