Appendix; Factory Reset; Factory Presets; Troubleshooting - TerraTec AXON AX 100 MKII Manual

Appendix

Factory Reset

Press and hold the PRESET and EXIT buttons while powering the device u p. All settings will be returned to
their factory defaults. As this also affects the presets, be sure to back them up beforehand with the Editor (see
SysEx)

Factory Presets

Factory presets were assigned to memory slots 129-256 to give you an overview of the wide range of pos sible
playing parameters. You can also use the factor y presets as a starting point for your own experimentation,
editing them to suit y our wishes. Edited factory presets can be stored in any of the slots within the USER range
(1-128).

Troubleshooting

No output to external MIDI output device.
Question: When I pla y my guitar, the AXON responds by displaying the pitches or the string level on the dis-
play, but the MIDI output device does not play.
Possible fau lt: Cabling/setup
Solution:
Ensure that the MIDI cables are correctly connected (from the MIDI OUT of your AXON to the MIDI IN of your
synthesiser).
The MIDI channels of both instruments must be set correctly.
T he synthesiser should be in multitimbral mode.
Also ensure that the audio cable from your synthesiser to the amplifier is intact and correctly connected.
Bending doesn't work properly.
Question: I hear the right note when I pick a string, but hammer-on, pull-off and bending does not work.
Possible problem: The pitchbend settings of the AXON and the external device may not match, or "Quantize"
is enabled.
Solution:
Check whether the pitchbend range settings of the external MIDI device match those of the AXON (GLOBAL
MODE).
Ensure that the QUANTIZE value in the preset split (PRESET MODE) is set to AUTO or OFF.
I get partially incorrect notes.
Question: When I play my guitar, the notes I hear are either partially or completely wrong.
Possible problem: Tuning discrepancy.
Solution:
Tune your guitar using the AXON tuning aid. If you need to tune the AXON to match your guitar, use the Tune
Base function in GLOBAL MODE.
The transposition function may be accidentally enabled in the preset split. Disable transposition (PRESET
MODE).
AXON AX 100 MKII V. 2.0 (English) 57