Typical M300 Setups - TC Electronic M300 User Manual

Connecting and Setting up the M300
Setting up the M300 is very easy. It is, however, important to connect and setup the M300 correctly
according to your application. Setting up basically means: connecting, selecting one of the two
routing options via the switch on the rear panel and finally setting the MIX control on the front panel.
Find the setup you are about to create or similar on the following two pages - and follow the
instructions.
Setup
M300 Routing Schematic
10
TYPICAL SETUPS
Dual Send/Return
This setup applies to a mixer with two (or
more) AUX sends. It utilizes the two effect
sections in the M300 as two separate effects
with a common Output.
• On the rear panel select DUAL S/R routing
• Connect AUX 1 send to the M300 Left Input.
• Connect AUX 2 send to the M300 Right
• Connect the M300 Left and Right Outputs to
• Set MIX to 100% wet, as you in this setup do
• Set Input level to 12 o'clock position.
• Set BALANCE to 12 o'clock position.
• Select Reverb type and Multi-effect type
• Set the AUX Return level on the mixer to
• Now slowly turn up the AUX Sends 1 and 2
• Adjust/fine-tune the M300 Input level so the
by leaving the switch in the "IN " position.
Input.
the Stereo AUX L/R returns of either AUX 1
or AUX 2.
not want the direct signal to pass the M300.
using the selectors on the front panel.
approx. 50%.
on the mixer for the channels you wish to
add effect to.
Input LED on the front panel often is Orange
but only rarely peaks at Red color.