Installing The Gui To Your Switch Via Tftp Server - Allied Telesis x600-24Ts Software Reference Manual

Installing the GUI to Your Switch Via TFTP server

Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
C613-50006-01 REV B
Download a GUI Java applet file from the support site:
From the Allied Telesis Support site
awp.html download the GUI Java applet file. This file has the .zip file name extension.
You need to extract the Java .jar file from the compressed .zip file.
Copy the GUI applet
Copy the GUI applet .jar file onto a TFTP server. Ensure this TFTP server is
enabled and ready for the switch. Connect to the management port of the switch,
then login to the switch. Do not connect to the management port of the TFTP server
Assign the IP addresses:
Use the following commands to configure your switch with an appropriate IP address:
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ip address <address>/<prefix-length>
Where <address> is the IP address that you will subsequently browse to when you
connect to the GUI Java applet. For example, to give the switch an IP address of
192.168.2.6, and a subnet mask of 255.255.255.0, use the following command:
ip address 192.168.2.6/24
awplus(config-if)#
Use the following commands to configure your switch with a default gateway::
awplus(config-if)# exit
awplus(config)# ip route 0.0.0.0/0 <gateway-address>
Configure the Default Gateway
In necessary, use the following commands to configure the default gateway.
awplus(config-if)# exit
awplus(config)# ip route 0.0.0.0/0 <gateway address>
Where <gateway-address> is the IP address for your gateway device. Note that you
do not need to define a default gateway if you browse to the switch from within its
own subnet.
Copy the GUI Java applet to your switch
Use the following commands to copy the GUI Java applet to your switch:
awplus# copy tftp://<server-address>/
<filename.jar> flash:/
Where <server-address> is the IP address for the TFTP server, and where
<filename.jar> is the GUI Java applet file you downloaded in step 1.
Software Reference for Allied Telesis x600 Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1-01
http://www.alliedtelesis.co.nz/support/updates/
C.5